Get the Classic Multiple-Carb Look and Modern Performance with a FiTech Go Vintage 97 EFI System at Summit Racing
FiTech's Go Vintage 97 EFI systems pair the look of traditional Stromberg 97 two-barrel carburetors with self-learning electronic fuel injection, in 2x2, 3x2 and 4x2 configurations rated up to 500 horsepower

TALLMADGE, OHIO — Back when gasoline was 30 cents a gallon and Bill Haley rocked around the clock, having multiple carburetors on your hot rod showed you meant business. Dual and triple setups were the most common (especially for flathead Fords), but four- and even six-carb induction was around. Even the factories offered multiple carburetor setups on their high performance models.
The downside to multiple carburetion was tuning. A lot of time was spent balancing the carburetors and setting up linkage so they worked just right. It was more black art than science, but they sure looked cool.
FiTech Go Vintage 97 EFI Systems give you the look of multiple carburetors without the tuning hassles. They combine the classic look of traditional Stromberg 97 two-barrel carburetors with the performance and drivability of modern electronic fuel injection.
Like all FiTech EFI systems, the Vintage 97 systems are self-learning, automatically adjusting and tuning the air/fuel ratio as you drive. One throttle body acts as the main unit. Instead of a secondary linkage arm, it has an integrated sensor package with throttle position, idle air temperature, and 1 bar MAP sensors that feed data to the ECU.
The main throttle body has a primary throttle linkage arm. The other throttle bodies have linkage arms on both sides, allowing you to set up the throttle linkage to fit your intake manifold setup. You’ll have to supply the linkage and the throttle body mounting hardware.
Other features include:
- Remote-mount Idle Air Control (IAC) module and ECU for a clean, vintage appearance
- Throttle bodies with two 36 lb.-hr. fuel injectors
- Fuel rail with fittings
- Main and fuel injector wiring harnesses
- Handheld controller
- Coolant temperature and oxygen sensors
- Electric fan output
You can set up your Vintage 97 system to control ignition timing with either a CD ignition box or a standalone distributor with a magnetic pickup. You can also fine-tune things like idle, fuel and spark maps, rev limiter, and other parameters to dial in the system for optimum performance. The instructions will explain these procedures.
Vintage 97 EFI Systems are available in these configurations. A single-throttle body system rated at 125 horsepower is also available:
- 2 x 2, 250 horsepower
- 3 x 2, 375 horsepower
- 4 x 2, 500 horsepower
The FiTech Go Vintage 97 EFI Systems are direct-fit for vintage factory and factory intake manifolds with the three-bolt Stromberg mounting pattern. Summit Racing has compatible intakes for these engines:
- Edelbrock C-357-B 3 x 2 for small Chevy
- Offenhauser 3 x 2 for small Chevy
- Edelbrock Dual- and Triple-Carb for Ford Flathead V8
- Offenhauser Dual- and Triple-Carb for Ford Flathead V8
- Offenhauser 3 x 2 for Mopar 229-270 Poly
Check out FiTech Go Vintage 97 EFI Systems at Summit Racing Equipment, www.summitracing.com, 1-800-230-3030.
Media contact
Alan Rebescher, Summit Racing EquipmentThis release was issued by Summit Racing and is republished here with a link to the original. Brand representatives can request an edit or removal.


